View Full Version : Technical
- Winter Cover
- Outboard Discussions
- Mileage
- rudder discussions
- Self steering systems - Wind Vanes
- Boat creaks, should I groan?
- Cabin Interior--Slider Doors
- Hull / Deck Joint
- encapsulated ballast
- Cleaing scuff marks
- Roller Furling
- Halyard Cheek Blocks
- Adjustable Backstay
- interior-paint,laminate,veneer?
- Holding Tanks
- Boarding Ladders
- Deck Delamination / Core Problems
- coamings
- Winch Handles--Ariel #39
- masthead problem
- Coamings
- Bilge Pump Discussions
- Gennaker/Asymetrical Spinaker
- Bow Pulpit / Stern Rail / Push Pit
- Out Board Plug
- Gooseneck
- Harken roller furler
- Tiller Discussions
- Replacing Portholes
- Head sails
- Refrigeration
- Mast step discussions
- interior painting questions
- Fiberglass Repair Advice Neede
- removing seacocks
- mike g and yawl conversion
- Running Rigging
- Teak Rub Rail
- Jib and genoa tracks??
- Main Sheet Traveler
- Upper rudder shaft bushing replacement.
- Outboard Well
- Maximum Destruction
- insurance
- Boom vang
- Unknown Parts
- boom gallows
- Painting The Hull
- Cracked Scupper Tube
- Waterline is where
- Tenders
- lazarette repairs
- Trailer Discussions
- Stepping the mast
- Zinc Grounding
- Handrails ARIEL
- Sink Drain
- Commanders Head
- Boat Restoration--The Ugly Truth
- Batteries - Current & Lightning - Oh My
- Where to buy Non-Skid?
- steering failure
- NUMBER OF BOATS PRODUCED
- Ventillation Cowl at Bow
- steering failure
- Ariel weight?
- Yawl conversion
- Painting The Interior
- Interior pictures of Pearson Ariel??
- Marinium Fittings
- Re-bedding Hardware
- Sail dimensions and Sailmakers
- vibration
- Rotted Wood Combing
- Lifelines and Stanchions
- Headliner
- Forepeak Cabinsole
- Replacing Atomic 4
- Standing Rig
- Electrical Panel
- Threads of note
- deck scuppers
- Solar Power, Panels, Charging, Etc.`
- The oft discussed outboard extra ballast revealed
- Safety at Sea/Man Overboard
- Masthead antenna installation
- Stripping paint
- blue gel coat news
- WHAT IS THE BEST NON-SKID ??
- FORWARD HATCH IDEAS.
- Winch handle foundry marks
- Max Hull Speed & Other Computations
- RIGID VANG
- Storm Jib for a Commander
- paranoia subsides
- jewelry
- Interior blisters?
- GO WINDOWS
- Lifelines, Geboa, Jib
- Outboard Motor Fit
- Ariel #104 Thistle Dew, time to refit / refurbish
- Garhauer Lifting Davit
- Finally, A Truly Useful Project
- Safety Alert - Ring Cotter Pins
- Safety Alert - masthead pulley for foresail
- Standing Rigging
- Roller Furler
- Curtains
- Brightwork - oil or laquer?
- Prospective Boat Buyers Info-tech ?'s
- Weather stripping
- Sheds
- topping lift setup
- Navigation Lights
- Tiller fell off!
- Safety Question - Sailing Solo
- rudder bearing source
- food grade polyethylene?
- outboard motor remote controls
- Painting topsides
- Masthead Sheave for Main Halyard
- Commander and Outboards
- Backstay Chainplate Discussions [pg 152 in Manual]
- Shrink wrap winter covers
- Refurbish Question
- mercanti Aquatek
- jib track placement
- Battery location poll
- How do you spell lassarette?
- Dual headstays?
- Another question about a word - Block
- CD-25
- Whisker / Spinnaker Pole
- Thru-Hull Nightmares
- New Hi-Tech Search & Rescue Vessel
- mast electrical connector
- Propane Powered Outboard Motor......?
- Using a wood other than teak or mahogany?
- Mast/Boom Hardware Attachment- Corrosion
- Commander Pics and Sail Dimensions
- High Aspect Main
- Deck joint-Who, What and When
- Replacing Deck Tread Pattern
- Cockpit led halyards
- lost accesshatch
- Outboard Exhaust
- ANCHORING
- Dri-Z-Air
- Gennaker
- Outboard Well & Gas Fumes
- Should we make a Gallery forum?
- Outboard Well Baffle
- Rudder/Shaft Wiggle
- Briggs and Stratton outboard!
- Commander Emblems
- Pooling Water on Deck
- Dodgers anyone?
- Electricians- Help
- Fender Boards
- Epoxy VS. Polyester
- water tank
- dingy storage
- Mast Step/ Core
- Balancing Weight in Forepeak
- Let's Talk Rudders
- Rudder Bearings
- Location for holding tank for new head
- Removing Atomic 4
- Masts!?!
- Commander Compression Post Discussions
- Hull Shape
- Cabin Sole Refinishing
- Oar locks
- hull insulation
- Wet seats
- cutter conversion
- inspection ports
- Fixing a Hole to keep my mind from wandering
- Oops traveler
- windows in manual
- the fluoroelastomer caper
- motor mounts
- engine dies, but why
- Leading Lines Aft: Clutch / organizer / Winch Placement
- Spreader Socket Broken
- Haulout
- Replacing Micarta Laminate
- Mainsail track lube
- water tank coating
- Polishing/rubbinb Compounds
- Season Prep for Water Tank
- Outboard Exhaust in Lazarette
- Epoxy, epoxy, epoxy....
- Mast Step and light
- STRONGBACK DISCUSSION etc.
- Stanchions
- ??? Atomic4 reliability
- sailplan/dimensions?
- Scratched / Crazed Plexiglas
- running backstays
- Marine Etiquette - Bloody Sails
- Nissan 9.8hp BEP2 Remote Control
- Tranporting boat with motor in well
- Why Things Take So Long
- Sails - Paint, dye, bleach
- relaxed rig
- mystery drip
- ALTERNATIVE MAINSHEET CONTROL?
- mainsheet line
- SPINNAKER QUESTION
- fixed port frames
- Garhauer Service sucks!
- Garhauer lifting davit
- Outboard Power
- trailering an Ariel?
- Depth in hull transducer
- Garhauer Traveler Track
- Commander Cradle dimensions
- Stainless, Cont
- Commander Cockpit Awning?
- 4 stroke outboard choice
- Tabernacle Operation
- Radar on the Commander
- Relatively quiet, less smokey 2-strokes
- Anchor roller
- rudder fairing
- Wood Trim on the Commander
- water in gas
- RUDDER SHOE DISCUSSIONS
- Broken Rudder Shaft
- Blisters
- manganese or silicone bronze?
- Painting over wood grain veneer
- rudder drawings
- Topping Lifts
- Rotting away and lost in the Bay!
- Preserve your BACK-Bucket under the boat, new home.
- Rudder
- Need Spreaders
- keel voids
- hull sanded do I have to seal it before winter
- Single-Handed Ariel
- Mizzen Staysail gear
- Cheap Electronics Mount
- Galley Cooktop Choices?
- atomic-4 speed and stress
- rudder again
- Reefing Systems
- Sail stop at bottom of mast track
- gas or diesel
Powered by vBulletin™ Version 4.0.3 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.