View Full Version : Technical
- Galley Cooktop Choices? (20 replies)
- Cheap Electronics Mount (1 replies)
- Mizzen Staysail gear (7 replies)
- Single-Handed Ariel (30 replies)
- hull sanded do I have to seal it before winter (10 replies)
- keel voids (76 replies)
- Need Spreaders (3 replies)
- Rudder (3 replies)
- Preserve your BACK-Bucket under the boat, new home. (6 replies)
- Rotting away and lost in the Bay! (16 replies)
- Topping Lifts (6 replies)
- rudder drawings (1 replies)
- Painting over wood grain veneer (2 replies)
- manganese or silicone bronze? (9 replies)
- Blisters (8 replies)
- Broken Rudder Shaft (4 replies)
- RUDDER SHOE DISCUSSIONS (61 replies)
- water in gas (4 replies)
- Wood Trim on the Commander (8 replies)
- rudder fairing (21 replies)
- Anchor roller (65 replies)
- Relatively quiet, less smokey 2-strokes (15 replies)
- Radar on the Commander (12 replies)
- Tabernacle Operation (17 replies)
- 4 stroke outboard choice (9 replies)
- Commander Cockpit Awning? (3 replies)
- Stainless, Cont (13 replies)
- Commander Cradle dimensions (3 replies)
- Garhauer Traveler Track (9 replies)
- Depth in hull transducer (23 replies)
- trailering an Ariel? (18 replies)
- Outboard Power (15 replies)
- Garhauer lifting davit (2 replies)
- Garhauer Service sucks! (7 replies)
- fixed port frames (2 replies)
- SPINNAKER QUESTION (22 replies)
- mainsheet line (7 replies)
- ALTERNATIVE MAINSHEET CONTROL? (23 replies)
- mystery drip (12 replies)
- relaxed rig (5 replies)
- Sails - Paint, dye, bleach (11 replies)
- Why Things Take So Long (19 replies)
- Tranporting boat with motor in well (4 replies)
- Nissan 9.8hp BEP2 Remote Control (13 replies)
- Marine Etiquette - Bloody Sails (2 replies)
- running backstays (1 replies)
- Scratched / Crazed Plexiglas (1 replies)
- sailplan/dimensions? (5 replies)
- ??? Atomic4 reliability (5 replies)
- Stanchions (12 replies)
- STRONGBACK DISCUSSION etc. (89 replies)
- Mast Step and light (24 replies)
- Epoxy, epoxy, epoxy.... (7 replies)
- Outboard Exhaust in Lazarette (0 replies)
- Season Prep for Water Tank (18 replies)
- Polishing/rubbinb Compounds (1 replies)
- water tank coating (3 replies)
- Mainsail track lube (7 replies)
- Replacing Micarta Laminate (10 replies)
- Haulout (9 replies)
- Spreader Socket Broken (22 replies)
- Leading Lines Aft: Clutch / organizer / Winch Placement (15 replies)
- engine dies, but why (5 replies)
- motor mounts (6 replies)
- the fluoroelastomer caper (14 replies)
- windows in manual (5 replies)
- Oops traveler (5 replies)
- Fixing a Hole to keep my mind from wandering (6 replies)
- inspection ports (3 replies)
- cutter conversion (5 replies)
- Wet seats (12 replies)
- hull insulation (7 replies)
- Oar locks (42 replies)
- Cabin Sole Refinishing (53 replies)
- Hull Shape (11 replies)
- Commander Compression Post Discussions (59 replies)
- Masts!?! (6 replies)
- Removing Atomic 4 (15 replies)
- Location for holding tank for new head (43 replies)
- Rudder Bearings (4 replies)
- Let's Talk Rudders (12 replies)
- Balancing Weight in Forepeak (27 replies)
- Mast Step/ Core (41 replies)
- dingy storage (4 replies)
- water tank (22 replies)
- Epoxy VS. Polyester (22 replies)
- Fender Boards (23 replies)
- Electricians- Help (9 replies)
- Dodgers anyone? (41 replies)
- Pooling Water on Deck (13 replies)
- Commander Emblems (31 replies)
- Briggs and Stratton outboard! (1 replies)
- Rudder/Shaft Wiggle (2 replies)
- Outboard Well Baffle (3 replies)
- Should we make a Gallery forum? (7 replies)
- Outboard Well & Gas Fumes (5 replies)
- Gennaker (8 replies)
- Dri-Z-Air (0 replies)
- ANCHORING (49 replies)
- Outboard Exhaust (27 replies)
- lost accesshatch (5 replies)
- Cockpit led halyards (15 replies)
- Replacing Deck Tread Pattern (10 replies)
- Deck joint-Who, What and When (87 replies)
- High Aspect Main (5 replies)
- Commander Pics and Sail Dimensions (2 replies)
- Mast/Boom Hardware Attachment- Corrosion (2 replies)
- Using a wood other than teak or mahogany? (3 replies)
- Propane Powered Outboard Motor......? (14 replies)
- mast electrical connector (3 replies)
- New Hi-Tech Search & Rescue Vessel (4 replies)
- Thru-Hull Nightmares (37 replies)
- Whisker / Spinnaker Pole (35 replies)
- CD-25 (4 replies)
- Another question about a word - Block (15 replies)
- Dual headstays? (4 replies)
- How do you spell lassarette? (5 replies)
- Battery location poll (39 replies)
- jib track placement (82 replies)
- mercanti Aquatek (3 replies)
- Refurbish Question (9 replies)
- Shrink wrap winter covers (0 replies)
- Backstay Chainplate Discussions [pg 152 in Manual] (71 replies)
- Commander and Outboards (29 replies)
- Masthead Sheave for Main Halyard (7 replies)
- Painting topsides (3 replies)
- outboard motor remote controls (4 replies)
- food grade polyethylene? (8 replies)
- rudder bearing source (26 replies)
- Safety Question - Sailing Solo (18 replies)
- Tiller fell off! (12 replies)
- Navigation Lights (150 replies)
- topping lift setup (8 replies)
- Sheds (27 replies)
- Weather stripping (1 replies)
- Prospective Boat Buyers Info-tech ?'s (38 replies)
- Brightwork - oil or laquer? (20 replies)
- Curtains (16 replies)
- Roller Furler (75 replies)
- Standing Rigging (94 replies)
- Safety Alert - masthead pulley for foresail (0 replies)
- Safety Alert - Ring Cotter Pins (24 replies)
- Finally, A Truly Useful Project (2 replies)
- Garhauer Lifting Davit (1 replies)
- Ariel #104 Thistle Dew, time to refit / refurbish (24 replies)
- Outboard Motor Fit (6 replies)
- Lifelines, Geboa, Jib (7 replies)
- GO WINDOWS (1 replies)
- Interior blisters? (4 replies)
- jewelry (7 replies)
- paranoia subsides (28 replies)
- Storm Jib for a Commander (3 replies)
- RIGID VANG (23 replies)
- Max Hull Speed & Other Computations (8 replies)
- Winch handle foundry marks (2 replies)
- FORWARD HATCH IDEAS. (16 replies)
- WHAT IS THE BEST NON-SKID ?? (2 replies)
- blue gel coat news (3 replies)
- Stripping paint (25 replies)
- Masthead antenna installation (5 replies)
- Safety at Sea/Man Overboard (20 replies)
- The oft discussed outboard extra ballast revealed (68 replies)
- Solar Power, Panels, Charging, Etc.` (46 replies)
- deck scuppers (48 replies)
- Threads of note (1 replies)
- Electrical Panel (2 replies)
- Standing Rig (2 replies)
- Replacing Atomic 4 (26 replies)
- Forepeak Cabinsole (1 replies)
- Headliner (21 replies)
- Lifelines and Stanchions (15 replies)
- Rotted Wood Combing (53 replies)
- vibration (1 replies)
- Sail dimensions and Sailmakers (10 replies)
- Re-bedding Hardware (28 replies)
- Marinium Fittings (1 replies)
- Interior pictures of Pearson Ariel?? (23 replies)
- Painting The Interior (27 replies)
- Yawl conversion (22 replies)
- Ariel weight? (3 replies)
- steering failure (3 replies)
- Ventillation Cowl at Bow (37 replies)
- NUMBER OF BOATS PRODUCED (0 replies)
- steering failure (0 replies)
- Where to buy Non-Skid? (4 replies)
- Batteries - Current & Lightning - Oh My (19 replies)
- Boat Restoration--The Ugly Truth (53 replies)
- Commanders Head (4 replies)
- Sink Drain (18 replies)
- Handrails ARIEL (50 replies)
- Zinc Grounding (30 replies)
- Stepping the mast (4 replies)
- Trailer Discussions (95 replies)
- lazarette repairs (38 replies)
- Tenders (83 replies)
- Waterline is where (7 replies)
- Cracked Scupper Tube (1 replies)
- Painting The Hull (74 replies)
- boom gallows (2 replies)
- Unknown Parts (26 replies)
- Boom vang (11 replies)
- insurance (4 replies)
- Maximum Destruction (11 replies)
- Outboard Well (35 replies)
- Upper rudder shaft bushing replacement. (12 replies)
- Main Sheet Traveler (60 replies)
- Jib and genoa tracks?? (19 replies)
- Teak Rub Rail (1 replies)
- Running Rigging (30 replies)
- mike g and yawl conversion (2 replies)
- removing seacocks (1 replies)
- Fiberglass Repair Advice Neede (14 replies)
- interior painting questions (8 replies)
- Mast step discussions (93 replies)
- Refrigeration (33 replies)
- Head sails (10 replies)
- Replacing Portholes (66 replies)
- Tiller Discussions (103 replies)
- Harken roller furler (6 replies)
- Gooseneck (45 replies)
- Out Board Plug (15 replies)
- Bow Pulpit / Stern Rail / Push Pit (74 replies)
- Gennaker/Asymetrical Spinaker (4 replies)
- Bilge Pump Discussions (121 replies)
- Coamings (20 replies)
- masthead problem (3 replies)
- Winch Handles--Ariel #39 (57 replies)
- coamings (45 replies)
- Deck Delamination / Core Problems (198 replies)
- Boarding Ladders (64 replies)
- Holding Tanks (16 replies)
- interior-paint,laminate,veneer? (6 replies)
- Adjustable Backstay (25 replies)
- Halyard Cheek Blocks (10 replies)
- Roller Furling (2 replies)
- Cleaing scuff marks (3 replies)
- encapsulated ballast (16 replies)
- Hull / Deck Joint (27 replies)
- Cabin Interior--Slider Doors (22 replies)
- Boat creaks, should I groan? (10 replies)
- Self steering systems - Wind Vanes (69 replies)
- rudder discussions (491 replies)
- Mileage (5 replies)
- Outboard Discussions (249 replies)
- Winter Cover (13 replies)
Powered by vBulletin™ Version 4.0.3 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.