Still chipping away at the 2gm. New zincs, fuel filter and I replaced the couple of fasteners I chose to cut to remove the engine. I also slapped (and I do mean slapped) some new Yanmar grey paint on it. Time to deal with the engine room if I can get a day that isn't super cold or raining. Plan to cut out the rear engine mounts and replace them then clean, sand and repaint the whole area before re-installing the engine.
I'm thinking of tearing out most of the existing wiring. It's all pretty old (much original I'd guess) and some of it is confusingly complicated for what it is. I need to dig around more but that's the way it's headed I think.
Also need to make a hinge for the foot of the mast (is this a tabernacle or is that specifically the type that leaves a couple feet of mast on the step before the hinge?) and a bow roller for the new-to-me Bruce 33 that'll be up front.
Scored a mooring recently too at Broad Cove in Cumberland, Maine. About 20 minutes from the house in the municipal field. It's an unpopular spot because of the long tender ride out (read row in my case) to the field, the shallow (and this year no) dock and it's a long walk to the water from the car. But It's all mine! I'll be dragging a 10' row boat with a 2 year old and all his stuff over the mud every low tide I get a chance to. Super excited!!