Results 1 to 15 of 104

Thread: Tiller Discussions

Threaded View

  1. 05-24-2008 06:33 PM #20
    mbd
    mbd is offline Registered User mbd
    Join Date
    Jan 2004
    Location
    Scarborough, Maine
    Posts
    1,439

    Custom Tiller Fitting

    Ok. Here we go. And pardon the "workmanship". (It's a bit embarrassing after Rico's mast base.)

    I drilled 2 5/16 holes in the top of my tiller fitting, then "squared" them with a dremel to fit bronze carriage bolts. (1/2 way done in the pic.) I also "squared" the middle hole in the side to fit a third carriage bolt.
    Attached Images  
    Last edited by mbd; 05-24-2008 at 06:56 PM.
    Mike
    Totoro (Sea Sprite 23 #626)
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Similar Threads

  1. sheet to tiller 'self steering'
    By frank durant in forum Technical
    Replies: 10
    Last Post: 11-14-2005, 11:30 AM
  2. Tiller fell off!
    By Janice Collins in forum Technical
    Replies: 12
    Last Post: 11-05-2002, 08:52 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules