Ebb: "Portrait of the port side toerail"
Ebb: "Portrait of the port side toerail"
Ebb: "Finally the OB motor well gets its primer coat, albeit lots of runs, but relatively easy to sand. Wish I could get somebody else to do it!"
Last edited by Bill; 08-01-2006 at 09:30 AM.
Ebb: "This shows the dodger from the cockpit. The piece is made from xmat and epoxy over a form. 1/2-inch pvc foam was bent and glued to that and more xmat on top. Classic sandwich. Works in progress have many unknowns and surprises. How it will actually finish up can't tell (ideas, anyone?) - or even if it will have a place there aesthetically. Unlike Geoff, who has the area covered, the dodger proposed here is only a windscreen requiring an expensive pipe and canvas pram hood to fully protect the c'way. Dodger has its own bridge over the c'way making it independent of the seahood. There's a choice whether it will be permanently installed or made removable. Picture shows the big side hatch-slide rails now built in. They run the length of the cabin top and the seahood (also removable) mounts there on. Note taller coamings extending up from the inside and the mockup of a flat hatch."
Ebb: "This shot shows the seahood made with the original sliding hatch. There may be room under the forward part for a dorade. Dodger shows some off-the-wall possible windows. I had planned 3/8" carbonate for these - but bending the plastic to those curves is totally daunting. Center window indicates a Taylor-Made opening hatch."
Ebb: "Starboard locker conversion to water tank. Doorskin to the bulkhead with the pencil lines proposes cutting the bulkhead back even further."
Ebb: "This is a trial idea in doorskin. What are the pros and cons? The laminated beam would go under the one already there (too massive! lost head room!). But it would open up the longer berth room the skipper requires. The doorskin shows a compass curve, the strongest architectural shape possible, in the only form possible, or am I missing something. The present compression beam with its struts imho is perfectly adequate. The arch is strangely more pleasing to me than what's there."
Ebb: "Deck has been lowered to accommodate 19.5-inch height of AirHead head. Discovered, after the yard leveled the boat, that the V'berths are higher at the fore end by 3/4-inch."