Commander 227

[Commander227]

I have not had much time for the Princess lately and spring is right around the corner. Average Ice out for Lake Minnetonka is April 15th. To quote some dude in a flannel shirt, "git er dun"
Pic #1; Rudder about ready to install after cutting the prop aperture, glassing and gel coat. just need to sand and apply the VC-17.
Pic #2; Motor assy. set in place, needs to be aligned with the shaft, but I had to send the shaft to the machine shop to have the keyway lengthened.(sure wish I could learn to read a tape measure).
Pic #3; Bulkhead trimmed and varnished, still need to make the rest of the interior trim and the door to the head and touch up the cuddy paint. (also install the head)
Pic #4&5; Fabricated and installed the new companionway sill. I did this before fabricating the rest of the trim to be sure I had the right angles and a good fit. Need to finish the last few coats and install remaining pieces.