-
jib halyard tang
In case anyone missed what I found on 338's mast -
That fitting that attaches the jib halyard block to the mast over the big wire sheave was badly corroded. Dangerously corroded.
(post 23 - on the underside in the before shot
and on the top of the spar in the after shot.)
The tang was held on with 4 #12 machine screws. On my mast the aluminum was just about completely reduced to white powder under the fitting.
I think it's worth taking a look under this tang.
Last edited by ebb; 11-21-2008 at 10:18 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules