Fruits Of My Labor (A-113)

[ebb]

Stem Strap. Yes many boats have that. Would save weight if you're going with anchor roller/channels.Remember you have to incorporate another attachment point for the foot of the sail.
Another plate.
Bingham, (the Sailor's Sketchbook pg80/81) has idea drawings of stem and double anchor roller weld ups which might be very useful for a small cruiser. Something like that would slip over the Ariel nose.
And maybe even reuse the 8" bolt for the major attachment. That's the one that goes through the top hole in the original and exits through curve of the toerail/nose. Imco a VERY strong forestay attachment method.


If your Solent is coming from a lower position on the mast but to the stemhead fitting, don't you already have a third hole in the fitting that can be used for that?

[Tony G]

If your Solent is coming from a lower position on the mast but to the stemhead fitting, don't you already have a third hole in the fitting that can be used for that?

Our current plan is to attach the solent as close to the top of the mast as I can get without interfering with the furler. (I know the furling vs. hank on argument-but I have a new furler and new head sail cut to it so I'm going to use it.) Then put a (what do you call it?) fitting about two feet back from the stem. A line drawn through these two points would intersect a point on the sheer a few inches above the waterline . That point is about as far as I can comfortably reach over the side of the bow. So I think that would be a good place to mount a sturdy 'U' bolt or eye that an anchor chain snubber could be attacted to. The backing hardware for this snubber attachment point could serve as an attachment for even more hardware that would secure the solent's hardware to the hull as well as the deck thereby taking some of the strain off of the deck whe the solent is being used. If we add a couple of inches of teak into the mix for an anchor platform/sprit that should strengthen everything up a little more yet.

[ebb]

GOT IT!
Actually got it backwards.
If the reason for a solent stay is because you have a permanent furler on the forestay, then in theory the solent will be used for the storm sail - hanked on.
That would mean you can put the attachment point for the solent as far forward as you need to and even get a decent sized staysail.

The attachment for a storm sail in the Ariel deck is pretty technical, I think.
If the solent is more forward then the 'U-bolt' can be backed up with a turnbuckle to a strongpoint built into the stem. I mean a turn buckle more forward would be less in the way in the chain locker.

[At one point I imagined a reverse eye in the stem, attached thru the stem with the eye inside!
Desperate measures - don't know if it is practical - but you do need imco more backup than what you can get with our composite deck and plywood.]

A Solent stay is a movable stay.
ABI is out of business and their Hyfield lever no longer available.
Johnson makes a nice backstay turnbuckle with integrated levers for tensioning that have been used for Solent stays by others.
Might be worth looking into. 5/16", $400!

[Tony G]

wether you spell it hyfield or highfield it is high bucks and hard to find! I've run across a few used ones but they have been for a much bigger stay diameter than practical for my needs.

Some plan-B, C and D ideas include: