Davee,
How you get a 4" disk in a 1 1/2" hole? A carbide burr will do a fine 4 or 5 degree taper. I'll taper the above hole in 30 seconds with the half-round 49 while you're still fidlding with the chuck key!
Davee,
How you get a 4" disk in a 1 1/2" hole? A carbide burr will do a fine 4 or 5 degree taper. I'll taper the above hole in 30 seconds with the half-round 49 while you're still fidlding with the chuck key!
Last edited by ebb; 07-09-2004 at 07:01 AM.