-
bilge hole
Kyle, just chatting here. Don't have an answer. Just questions.
Seems to me a better location for chart plotters would be higher
up in a more horizontal location. And that would be more likely
for other electronics thru-hulls.
Scares me a hole that deep and inaccessible, Maybe it should be
permanently closed off, removed and fiberglassed.
If manufacturers have each proprietary thru-hulls then you should
it seems install the recommended system, rather than jerry an
old hole. Gook luck!
(Also assume that's a metal fitting. You don't know what kind of
bronze or brass it is. Could be weakened, anything. Gives you
an opportunity to put in the kind of thru-hull you trust.)
Last edited by ebb; 05-20-2017 at 10:13 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules