-
Hey Jerry, sure looks good. One thing to remember when test fitting:
You need around a half inch gap between the hull and the top of the rudder so you can lift it high enough to get it into the shoe. You can just make a notch around the shaft and turn it to one side when installing. I made this mistak when I built my first Ensign rudder and had to hack into my masterpiece at the boat yard cause I was installing and launching at the same time. I could not test fit without lifting the boat from the trailer.
Mike
C227
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules