I did it a little different using teak vaneer, but then my choices were limited. The Micarta was warping and falling off, so it had to come off. The only question regarded how much I took off.

As it turned out, it all came off except for the aft bulkhead, including above the sink. I then used 3M contact cement and put on 10 mil teak vaneer. If I were to do it again, I think I would use the self stick vaneer. The contact cement I used, which is industrial stuff, is too lethal if there is a mistake, and it is virtually impossible, in my opinion, to adequately smooth it out.

But outside of these small matters, the teak interior looks spectacular and warm. The fiberglass sides are painted white.