Hello all,
I'm ramping up to cut out (remove and replace) my bulkheads and lower chain plate knees and can't visualize the right cutting tool that will accomodate the task of cutting as close as possible to the hull without actually making contact.
Is there a cutting tool out there that cuts flush or close to, and will eat fiberglass and resin soaked plywood? Also one that will work in tight places.
It looks like I'll be adding to my tool inventory, just don't know what or where to look. For my backstay chainplate knee, I cut it out with a saw zaw, but I was hoping there is something better out there.
Some where a while back I'm thinking of a mention of a Master cutting tool. Am I right? What is it, and where do I find it.

Any help greatly appreciated.

Thanks.