-
The epoxy has set so I removed the wires that were holding the disk in place. The plan is to mix up a little more epoxy with filler and coat the disk so that it is fair with the backside of the hull. Then I will let that completely cure overnight. In the morning I'll remove the amine blush, sand the area fair, then prep, and finally begin laminating. I figure there will be close to fifteen layers of glass to bring it close to flush with the outside of the hull. Then I'll put a nice thin smooth coating of epoxy with filler to cap it off. Then bottom paint and I'll be done with this keel bulge thing.
Last edited by Tim Mertinooke; 04-19-2007 at 01:46 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules