And my first ever fiberglass job - phase one.
First, I slathered as much unthickened epoxy into the cracks as I could and wetted out the bare glass. Then I thickened what was left to fill the big gaps. Next I cut some of my 8.7 oz 4" fiberglass tape into 2" strips which I laid on the seams then wet out with unthickened epoxy.
I tried to roll out bubbles and squeegy off the excess before the epoxy gelled and became unworkable - with mediocre results. I got a can of slow hardener last weekend after I almost detonated my first big batch of epoxy, which gave me more time to work, but still, I attempted to do too big of an area at one time...
I would have liked to finish off with 4" strips and cloth to complete the scarf joints, but I ran out of daylight and weekend. Too bad, because the whole chemical vs. mechanical bond deal, but what can you do? Plan better, I guess.
I sure wish I had one of the experts looking over my shoulder! The job leaves much to be desired I'm sure, but at least the deck is getting put together instead of taken apart for a change. Besides, I can always grind it back down and try again, right?