Mike - Later this week, after I purchase the materials, I will be making up the first of my foam/plywood panels, I'll photo document that when it happens. I've been bouncing the idea off of everyone I know who might have input, and so far all have agreed that it should work wonderfully. I hope we're all right on that account...
Oh - our first good cold snap of the year has made me realize that I could use some insulation on the hull, so I also plan to go ahead and start installing the 2"-thick layer of foam against the hull in the main cabin area (above settee level), probably also towards the end of the week.
Todays 'of interest':
I did some cuttin' on the boat this AM. Since I'll be supporting the mast from underneath, I needed to know what structure was in place at the small step-up into the vberth (where the mast support will rest), and I have also wanted to open up the floor area in the v-berth for inspection, with an eye towards eventually cramming some of my positive-flotation foam in there, since I anticipated it would be too small for any real stowage.
The area is a little larger than I expected, so I am not sure what use I will put it to just yet, but here it is, exposed at last for contemplation.
Warning: work-safe pictures follow...
This shows the cut-out.
Reply With Quote