+ Reply to Thread
Results 1 to 15 of 83

Thread: jib track placement

Hybrid View

  1. #1
    Join Date
    Sep 2001
    Location
    San Rafael, CA
    Posts
    3,621

    Sail and Rig Tuning

    Going to own the Dedekam book, Thanks for the tip.
    Reviews are ALL positive, if not ecstatic, about his explanations and great diagrams.
    Amazon samples one page of colored graphics that alone makes this book look really exceptional.

    Local Barnes and Noble store don't have it in stock.
    But they'll get it delivered to me for $19.32 in four days.
    Last edited by ebb; 08-20-2010 at 07:24 AM.

  2. #2
    Join Date
    Sep 2001
    Location
    Asst. Vice Commodore, NorthEast Fleet, Commander Division (Ret.) Brightwaters, N.Y.
    Posts
    1,823
    I try not to partially furl the genoa. The boat performs better with a reef or two in the main instead.

    My genoa tracks don't run forward enough for a partially furled genoa either. I've experimented with using a "barber hauler" made up of snatch blocks on a short line attached to padeyes on deck. (like the small picture below). This way I can use the same genoa sheets and still pull the sheet down and inside a bit when the genoa is partially furled.

    There is a pretty good general discussion on genoa sheet leads at the UKHalsey website with a few diagrams

    http://www.ukhalsey.com/LearningCent...clopedia5b.asp

    I'll reproduce it here in case the link fails



    UK-Halsey's Encyclopedia of Sails
    -- Genoa Trim

    Chapter 1
    Chapter 2
    Chapter 3
    Chapter 4
    Chapter 5
    Main Sail Trim
    Genoa Trim
    Sailing to Telltails
    Chapter 6
    Chapter 7
    Chapter 8
    Chapter 9
    Chapter 10
    Last edited by Bill; 10-13-2010 at 11:03 PM.

+ Reply to Thread

Similar Threads

  1. Bilge Pump Discussions
    By commanderpete in forum Technical
    Replies: 121
    Last Post: 12-06-2018, 05:02 AM
  2. how many fair leads do we really need?
    By Anthony/Bina in forum Technical
    Replies: 9
    Last Post: 10-17-2004, 08:17 AM
  3. Sail stop at bottom of mast track
    By Theis in forum Technical
    Replies: 12
    Last Post: 12-17-2003, 07:16 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts