I'm working on Commander 94 and am planning on installing longer jib sheet tracks on the toe rail (boat has life lines). I just read/skimmed through the older thread on the subject but still had a question about bending the track. I would like to install a 6' section of 1" stainless steel track (similar I believe but longer than the original track used on these boats). this track seems to be quite stiff and am having doubts of whether it can be bent to follow the rail while installing. I was thinking the schaffer track referenced in the older thread in most cases may be the newer style aluminum extrusion and easier to bend?

Does anyone have experience with bending the 1" ss track? Can this be done?

I very much enjoy reading the technical forum here as I come up with qestions and develop my own plans for the boat.

Best regards,

Mark