Carl

I've been treating the epoxy work a lot like I do my woodworking. I always do a test clamp up when I glue up wood projects and use scrap pieces to test a tooling setup. So I always do a dry run for an epoxy layup also. I find I get better end results with less time (and money) invested by following that discipline.

For this project I only mixed 18oz's of epoxy at a time. I poured it straight from my mixing pot onto the deck and used a roller to roll it out. After each layer of glass was wet out I used a thin finned glass roller to roll out any bubbles in the material and then started all over again with the next layer. It went surprisingly well.