Insulating the hull questions.

[Hull376]

ebb,

Have glued in all the topside panels and the yogurt glue is holding well. And no smell! I've temporarily used some vinyl tape on the few seams until I decide on a permanent way to detail. For the v berth, I think I'm going to take the easy way out and simply insulate the horizontal flat surfaces and then maybe use appropriate stretchy white painty like product on the exposed cut edges of the dense closed cell foam. installing the panels in a couple of pieces in each cabin was a cinch. I found that a paintbrush was the best tool to lay on the 564 glue- better than a toothed trowel. The trowel, although a small one, couldn't conform to the dips and bumps in the fiberglass. It was leaving voids and pools!

So far so good!