Beautiful!
hello, here is some picture of the restoration of Grindel
hull whitout all old antifouling and treatment of the dozen osmosis blisters
underwater hull with 4 layer epoxy primer, 1
hanging layer and antifouling and rudder
epoxy laminate and rudder shoe
Last edited by grindel; 07-22-2019 at 07:14 AM.
cockpit reinforcement. on the hull 3 cm airex with rowing and polyester resin. and vertically 2.5x3 cm marine plywood with rowing and epoxy resin. horizontally 2x8 cm plywood
with fiberglass fabric that goes up along the cocpit
Last edited by grindel; 07-22-2019 at 07:08 AM.
strengthening the chain-plate
and new support for chandelier, 5x8x8 marine plywood bonded to epiglue and fiberglass and carbon and epoxy resin
reinforcement of the bridge under the winch and remove hood under the genoa sheet rail
Last edited by grindel; 07-22-2019 at 01:43 PM.
Attachment 10354
reinforcement of the bridge under the winch and remove hood under the genoa sheet rail
Attachment 10355
strengthening the chain-plate
and new support for chandelier, 5x8x8 marine plywood bonded to epiglue and fiberglass and carbon and epoxy resin
grindel at home