Geez! Something as simple as making a form for these coamings is surprisingly difficult! I can't find a line that goes behind the lazzarette hatch that looks smooth. Trying to mimic a CD36 coaming just doesn't fit on our deck (go figure!). The CD 330 and 36 have much wider decks back by the cocokpit and accomodate the wide sweep of the coaming right around and behind. Ours are a bit too...pinched? If you bring the aft portion of the coaming right through the middle of the lazzarette hatch, however, it looks pretty good. Sooo, the new thought is incorporating the aft section right into the lazzarette hatch... Then I thought, do I want a smaller hatch in the lazarette hatch or should I split it down the center line making it a left or right or both type of hatch? This is starting to seem like a lot of work just to reduce maintenance. Especially when you consider I'm adding mahogany toerails and rubrails.