Hey Ebb

I tried doing 1/16" deep kerf cuts every 1/4" on a what if mission in addition to steaming with the iron. It ended up with a sharp (8 degreeish) bend every quarter inch through the radius. Sure it could have been filled and sanded to work but it was a disappointing result for the amount of additional work that was put into this piece when compared to the other piece that came out of the form smooooth and shapely.

You used PVC? I didn't know that. I***assumed*** you either laminated your own or bought them ready made. I found a source for quarter round, 2" radius, 1/4" thick stock but the minimum order and shipping would have kept me in quarter round and full debt for a year or two :0