+ Reply to Thread
Page 1 of 3 1 2 3 LastLast
Results 1 to 15 of 37

Thread: An Embarrassing Story

  1. #1
    Join Date
    Sep 2001
    Location
    Orinda, California
    Posts
    2,311

    Unhappy An Embarrassing Story

    Last Saturday was the fourth monthly Inter Island Yacht Club Regatta. This time, the regatta was in the South Bay. The boat bottom had been scrubbed Thursday and the crew (Steve and Ebb) were hyped and ready for an exciting day.

    It was already windy at 11:00 AM. Early for the South Bay – usually, the wind shows there about an hour after the scheduled 12:30 PM start. When we arrived in the starting area, the race committee boat had not yet established the starting line. While waiting, we removed the outboard engine from the well and handed it to Ebb to stow in the companionway between the main and fore cabins.

    Meanwhile, we were bouncing around in the wind trying to set the sail trim when Steve yelled, “buoy!” I looked up and there it was. Big and Red and about 12 feet away. Dead ahead. At about 3 knots.

    Ebb reports that the noise below when we hit sounded like an explosion!

    The boat rolled off the buoy to leeward and headed off to starboard. I think I was in charge? We did an assessment of the damage and found a small bulge on the inner side of the bow that was weeping a bit, but no other punctures. Some nasty scrapes on the port side and the bow pulpit was a little messed up.

    Not really knowing if anything else might be awry, we decided to call it a day and sailed cautiously back to the Estuary and the slip.

    Once at the slip, closer examination showed that the bow pulpit had pulled up, leaving cracks around the forward base plates. That was it, other than what we found originally.

    A trip today to the yacht yard turned up a $2k estimate to repair it all.

    Here are the damage photos:
    Attached Images  
    Last edited by Bill; 07-12-2005 at 07:46 PM.

  2. #2
    Join Date
    Sep 2001
    Location
    Orinda, California
    Posts
    2,311
    The starboard foot on the pulpit:
    Attached Images  

  3. #3
    Join Date
    Sep 2001
    Location
    Orinda, California
    Posts
    2,311
    And the port foot . . .
    Attached Images  

  4. #4
    Join Date
    Sep 2001
    Location
    Orinda, California
    Posts
    2,311
    Then there's the pulpit istelf . . .
    Attached Images  

  5. #5
    Join Date
    Sep 2001
    Location
    Orinda, California
    Posts
    2,311
    The yard said they would not have a good handle on the damage to the deck around the pulpit bases until the removed the pulpit. It could be minor, or . .

    The yard is backed up a bit and they will not get to work on the boat until sometime next week. I can't wait . .

  6. #6
    Join Date
    Sep 2001
    Location
    Asst. Vice Commodore, NorthEast Fleet, Commander Division (Ret.) Brightwaters, N.Y.
    Posts
    1,823
    Sorry, but a buoy to leeward has the right of way. You were overtaking too. Wouldn't win that protest hearing.

    Of course, I've never hit a buoy.......except that one time.......

    Doesn't look too awful, aside from the pulpit.

    Gotta be ebb's fault somehow

  7. #7
    Join Date
    Sep 2001
    Location
    Santa Cruz
    Posts
    190
    Mr. Bill, Well stuff happens. You mention the yard being backed up. I assume you are speaking about Svens. If I can offer a little insight I would suggest you give Nelsons a try. A number of people I know that have used Svens lately have been very disappointed. The estimates have been way off, the time line dragged on for ever and the quality of work has been somewhat shabby. You might want to talk to Scott about his experience.

    On the other hand I hear nothing but good stuff about Nelsons. Their estimate might be a bit higher but it is honest and they have always done good work. ……ed

  8. #8
    Join Date
    Sep 2001
    Location
    San Rafael, CA
    Posts
    3,621

    Talking

    Wanna thank the Commadore for this expensive
    and very detailed lesson in tactical compression.

    As usual Ebb was not present, being somewhere
    else. The wind was UP and I thought I'd tuck
    Bill's ole Mariner into its sleeping bag. Yas, Bill's
    OB has his own cozy comforter!

    Was an horrendous noise,
    Never be the same any more.

    You shoulda seen them wide-eyed boys
    Ashakin' to the core.
    Last edited by ebb; 07-13-2005 at 07:02 AM.

  9. #9
    Join Date
    May 2004
    Location
    Pembroke Ontario Canada
    Posts
    591

    Talking 3 blind mice 3 blind mice

    OOPS !!! like the saying goes...'**** happens' While you are not the 1st nor the last to take on a marker bouy, I admire your bravery to post pics ! I once took on a channel marker bouy here at home..Ebb's right..the sound is the worst part..I figured we'd sink with all that noise,but only suffered a few scrapes. WOW Bill ....is your boat EVER yellow..you would of thought the marker would have saw YOU and got out of YOUR way. Happy racing
    Last edited by frank durant; 07-13-2005 at 05:20 PM.

  10. #10
    Join Date
    Jul 2004
    Location
    Winyah Bay, SC
    Posts
    605
    Ouch.

    Ouch, ouch, ouch!

    Best wishes for a speedy and complete (and hopefully as cheap as possible) recovery!

    I've always had a fear of accidently hitting a buoy and sinking my boat right next to it. Your pics have somewhat allayed my fears that a buoy could be an Ariel-slayer - yours looks like she handled the impact pretty well, considering.

    Did the buoy sink? I hope so...

    I'm with Frank - it took some chutzpah to post the pics - Thank you, Bill, for sharing.

    Don't let Ebb fix it - he'd probably try to sneak a bow thruster in there, and one of those retractable spinnaker poles.
    Kurt - Ariel #422 Katie Marie
    --------------------------------------------------
    sailFar.net
    Small boats, long distances...

  11. #11
    Join Date
    Sep 2001
    Location
    San Rafael, CA
    Posts
    3,621
    Bill like my idea of a truck tire on the bow.

  12. #12
    Join Date
    May 2004
    Location
    Pembroke Ontario Canada
    Posts
    591

    Talking spare tire...

    Ebb...a spare tire would be kinda tacky....how about wrap around 'baggywinkle' (spell check..Mike) like on an ole tugboat...much more charactor than a radial ply....much more fitting for a yacht the age of ours.A wonderful combination of charm and dam fine protection too !! May even increase your PHRF rating as an added bonus.

  13. #13
    Join Date
    Sep 2001
    Location
    Hampton Roads Va.
    Posts
    821

    Thumbs up Bow fender

    That actually would be a puddin or a mustache if it were on the bow of a tug , and it is baggy wrinkle not winkle ;>)

  14. #14
    Join Date
    Sep 2001
    Location
    San Rafael, CA
    Posts
    3,621

    Lightbulb

    A "puddin on the bow"
    sounds like just the thing.
    Have it designed like an airbag!

    Way it was blowing, we had to be closer to 6 knots.
    Way it sounded below, an EXPLOSION! 3 knots, NO WAY.

    Having a later number Ariel, I'm real glad I beefed up
    the stem on 338. Assuming that Bill's earlier edition is
    thicker in the stem. If it isn't (maybe the yard can
    take some photos of the cleaned out wound) THEN
    THAT SHOWS AN ARIEL CAN TAKE A REAL WHACK ON
    THE BOW.

    It would be a good idea to keep on board a two part
    quick set epoxy putty that could be smeared over a
    hole with or without some propylene fabric. There are
    epoxys that can be applied underwater to any surface.
    The fabric would be used primarily to span the hole if
    needed. You'ld apply the patch with a piece of vinyl
    film and hold it in place with a cushion. Maybe Marine
    Tex makes something like this?

    How about packaging it in a clear bag that would have the
    catalyst in a capsule inside that would be popped by
    squeezing, and then the bag kneaded to mix and activate.
    It should be a quick set repair, like 10 minutes. 10 ounces,
    10 year storage life, 30 bucks! yahsurebygolly.
    [As a kid, when margerine first came on the market, it was
    my job to pop the color cap and knead the white brick
    into an orange imitation of butter. I think butter went to war.]
    Last edited by ebb; 07-15-2005 at 07:30 AM.

  15. #15
    Join Date
    Jan 2004
    Location
    Scarborough, Maine
    Posts
    1,439
    Ah, so that's what you were was up to, eh Bill - demonstrating the ruggedness of the Ariel hulls! (Seriously, though, sorry to hear of the accident. )

    And you're right on Ebb. WM sells an Epoxy stick for around $13 which will cure underwater. It comes in a tube. you remove the putty, knead it until it turns white, then apply. I tried it out on my stern tube leak, but couldn't shimmy into the bilge through the cockpit locker far enough to really jam it in there. Tim L. is going to help me install the cockpit hatch tomorrow AM so we can get at the stern tube area to stuff a couple more putty sticks in there and hopefully make a decent temporary patch to get me through the rest of the season....
    Mike
    Totoro (Sea Sprite 23 #626)

+ Reply to Thread

Similar Threads

  1. My Story
    By commanderpete in forum Sailing and Events
    Replies: 6
    Last Post: 08-10-2007, 09:51 AM
  2. access hatches in cockpit are they original
    By Sprite in forum Technical
    Replies: 15
    Last Post: 07-15-2005, 05:54 PM
  3. hulldeck joint/and a story
    By walberts in forum Technical
    Replies: 20
    Last Post: 04-23-2005, 08:13 PM
  4. MOB Story
    By Ed Ekers in forum Sailing and Events
    Replies: 1
    Last Post: 12-26-2004, 04:05 PM
  5. Single Handed, Lake Michigan Storm story
    By Theis in forum General/Off-Topic
    Replies: 0
    Last Post: 10-03-2002, 07:23 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts