Mike -
Like Frank, both hands are up, and whatever color 'jealous' is, I am officially colored that shade, in a deep hue.
She's lookin' great!
Mike -
Like Frank, both hands are up, and whatever color 'jealous' is, I am officially colored that shade, in a deep hue.
She's lookin' great!
Last edited by CapnK; 05-21-2007 at 05:01 PM.
Kurt - Ariel #422 Katie Marie
--------------------------------------------------
sailFar.net
Small boats, long distances...
Mike, you could always rout a real cove into the hull. I was going to do that when I redid Dasein, but time got short so I didn't get to it. The plan was to screw a batten to the hull as a guide for a hand-held router with a (duh ) cove bit.
Last edited by dasein668; 05-23-2007 at 05:05 AM. Reason: typo!
Nathan
Dasein, Triton 668
www.dasein668.com
That's not a bad idea, then you could just paint it. But I've got a myriad of other projects that would take priority over routing a cove stripe - like copying your toe rails and cabin sole, not to mention the topsides...
Mike
Totoro (Sea Sprite 23 #626)
Befor you rout a cove into the topside of your Ariel or Commander make damn sure you are not creating a zipper that will separate your top from the bottom again!
338 has about 3/16" thickness near the seam with about 1/8" at the seam.
I urge you to drill some holes to measure actual thickness along the proposed track of your cove befor you take a router to it.
There is no doubt that an incised cove line with real gold leaf in it has way more class than any vinyl stripe.
Good point. Dasein has a solid 1/2 inch or more at that location. And a routed cove doesn't need to be very deep. You just need the right bit.
Nathan
Dasein, Triton 668
www.dasein668.com
If you're thinking about this classy style of coving, you have a variety of corebox bits to choose from. Depending on the width of the cove, it's obvious that the wider the bit the shallower the radius in the rout. So as dasein668 sez, you don't have to go deep to get a nice effect.
I wonder what is the best width for a cove stripe? Anybody know? It could be too narrow, or too wide for that matter....?
And what the hell is a corebox? Isn't it a 'coving' bit?
Last edited by ebb; 05-23-2007 at 07:44 AM.
Getting anxious to hit the water again...
Mike
Totoro (Sea Sprite 23 #626)